Typical Physical Properties Vintec I Units of Measure Value ASTM Method gcm3 R Scale D - 1.42 0.06 115 89 12454-B D 792 D 570 D 785 D 224 D 1784 psi psi psi psi ft-lbin 411000 7500 481000 12800 1.0 D 638 D 790 D 790 D 790 D 256 CF CF CF ininC IninF 83181 82179 80176 5.8 x 10-5 3.2 x 10-5 D1525 D 648 D 648 D 696 D 696 20 0 Self Extinguishing E 84 UL 94V D635 - Class B D 1784 Ohmcm 60 Hz 60 Hz 60 Hz Volts mil 5.4 x 1015 3.9 0.0096 0.030 544 D 257 D 150 D 150 D 150 D 149 Property Physical Density Water Absorption Rockwell Hardness Shore Durometer Cell Class Mechanical Tensile Modulus Yield Strength Flexural Modulus Yield Strength Izod Impact Strength Thermal Vicat Softening Point Heat Deflection Temp 66 psi Heat Deflection Temp 264 psi Coefficient of Linear Expansion Coefficient of Linear Expansion Flammability Ratings Flame Spread Index Flammability Flammability Chemical Chemical Resistance Electrical Electrical Volume Resistivity Dielectric Constant Dissipation Factor Loss Index Dielectric Strength 801 E. Corey Street Scranton PA 18505 Phone 800 235-8320 Fax 800 858-9266 www.vycomplastics.com Physical properties of plastic sheeting are represented as Typical. Information contained herein is considered accurate to the best of our knowledge. It is offered for your consideration and investigation and is not to be construed as a representation or warranty expressed or implied. Our warranties are limited to those expressly stated in formal contracts or in conditions of sale on our invoices and order acceptances. Conditions and methods of use may vary and are beyond the control of Vycom therefore Vycom disclaims any liability incurred as a result of the use of this product in accordance with the data contained in our physical property charts. No information herein shall be construed as an offer of indemnity for infringement or as a recommendation to use the products in such a manner as to infringe any patent domestic or foreign. The Typical properties of our plastic s
heet cannot be automatically used when engineering finished components and the fabricator or end user is responsible for insuring the suitability of our products for their specific application or end use UL is a registered trademark of United Laboratories.
